Home  > For Everyone  > Transportation  > {More Transportation Topics}  > Navigable Waters, Shipping and Watercraft  > Watercraft  > 46 CFR 59.10-10 - Corroded surfaces 
Search the Code of Federal Regulations

46 CFR 59.10-10 - Corroded surfaces

CFR > Title 46 > Chapter I > Part 59 > § 59.10-10. Corroded surfaces


Current as of: Oct. 2009

(a) Corroded surfaces in the calking edges of circumferential seams may be built up by welding to the original thickness under the following conditions:

(1) The thickness of the original metal to be built up between the rivet holes and the calking edge shall not be less than one-fourth of the diameter of the rivet hole, and the portion of the calking edge to be thus reinforced shall not exceed 30 inches in length in a circumferential direction.

(2) In all repairs to circumferential seams by welding, the rivets shall be removed over the portions to be welded for a distance of at least 6 inches beyond the repaired portion.

(3) After repairs are made the rivet holes shall be reamed before the rivets are redriven.

(b) It is not permissible to build up or reinforce a grooved or corroded area of unstayed internal surfaces by means of welding, except that widely scattered pit holes may be built up by welding.

(c) Where external corrosion has reduced the thickness of flat plates around hand holes to an extent of not more than 40 percent of the original thickness and for a distance not exceeding 2 inches from the edge of the hole, the plate may be built up by welding.

(d) Where stayed sheets have corroded to a depth not exceeding 40 percent of their original thickness, they may be reinforced or built up by welding. Where the staybolts are fitted with riveted heads, the staybolts in the reinforced area shall be renewed in accordance with the provisions of Sec. 52.20-15 of this subchapter, but where the staybolts are fitted with nuts, the nuts may be removed and after reinforcing has been applied, collars may be welded around the staybolts in lieu of the nuts. Such reinforced areas shall not exceed 400 square inches nor more than 30 inches in one direction. Two such areas in any one plate may be reinforced: Provided, that the distance between the reinforced surfaces is not less than 30 inches.

(e) When the corroded portion of a staybolted surface exceeds 400 square inches, it is permissible to make repairs by cutting out the defective portion and replacing it with a new plate, the edges of the new plate to be welded in position. In such cases, new staybolts shall be fitted in accordance with the requirements of Sec. 52.20-15 of this subchapter and where welding is performed through a line of staybolts, welded collars as required by Figure 52.01-3 of this subchapter shall be used to attach the staybolts.

(f) Eroded seams of welded pressure vessels may be repaired by rewelding the wasted portion. The wasted section of the seam shall be excavated sufficiently by grinding, flame or arc gouging or chipping to ensure proper weld penetration. Rewelded seams shall be nondestructively tested in accordance with section VIII of the ASME Boiler and Pressure Vessel Code (incorporated by reference, see 46 CFR 59.01-2).

[CGFR 68-82, 33 FR 18887, Dec. 18, 1968, as amended by USCG-2003-16630, 73 FR 65189, Oct. 31, 2008]
previous sectionPart 59 Table of Contentsnext section
Previous sectionPart 59 Table of ContentsNext section

________________________________________________________________________

State Laws: Watercraft

AlabamaAlabama Code > Title 33 > Chapter 5 - Registration And Operation Of Vessels
Alabama Code > Title 33 > Chapter 6 - Discharge Of Litter And Sewage From Watercraft
Alabama Code > Title 33 > Chapter 6A - Recreational Vessel And Residence Boat Sewage Discharges Regulated
AlaskaAlaska Statutes Chapter 05.25 - Watercraft
Alaska Statutes Chapter 30.30 - Abandoned And Derelict Vessels
ArizonaArizona Laws > Title 5 > Chapter 3 - Boating And Water Sports
CaliforniaCalifornia Harbors and Navigation Code > Division 3 - Vessels
California Harbors and Navigation Code > Division 4 - Masters, Crews And Cargoes
California Harbors and Navigation Code > Division 5 - Pilots For Monterey Bay And The Bays Of San Francisco, San Pablo, And Suisun
ConnecticutConnecticut General Statutes > Title 15 > Chapter 268 - Boating
DelawareDelaware Code Title 23 > Chapter 21 - Motorboats
Delaware Code Title 23 > Chapter 22 - Boating Safety
Delaware Code Title 23 > Chapter 23 - Operation Of A Vessel Or Boat While Under The Influence Of Intoxicating Liquor And/Or Drugs
Delaware Code Title 23 > Chapter 24 - Exemptions From Civil Liability For Rendering Vessel Traffic Information Services
FloridaFlorida Statutes > Title XXIV - Vessels
Florida Regulations Chapter 61B-60 - Yacht and Ship Brokers
Florida Regulations > Division 68D - Vessel Registration and Boating Safety
IdahoIdaho Code Title 67 > Chapter 70 - Idaho Safe Boating Act
IllinoisIllinois Compiled Statutes > 625 ILCS 45 - Boat Registration and Safety Act
IndianaIndiana Code > Title 9 > Article 31 - Watercraft Titling And Registration
Indiana Code > Title 25 > Article 28 - Boat Pilots
KansasKansas Statutes > Chapter 32 > Article 11 - Boating And Water Activities
MaineMaine Revised Statutes > Title 10 > Chapter 204-B - Watercraft Manufacturers, Distributors And Dealers
Maine Revised Statutes > Title 10 > Chapter 212-A - Maine Marina And Boatyard Storage Act
Maine Revised Statutes > Title 10 > Chapter 627 - Vessels
Maine Revised Statutes > Title 12 > Chapter 935 - Watercraft And Airmobiles
Maine Revised Statutes Title 23 > Chapter 412 - Waterborne Transportation
MassachusettsMassachusetts General Laws > Part I > Title XIV > Chapter 90B - Motorboats And Other Vessels
MichiganMichigan Laws > Chapter 123 > Act 68 of 1957 - Regulation Of Houseboats
Michigan Laws > Chapter 445 > Act 88 of 1989 - Watercraft And Outboard Motor Manufacturers, Distributors, And Dealers
MinnesotaMinnesota Statutes Chapter 86B - Water Safety, Watercraft, and Watercraft Titling
MissouriMissouri Laws > Title XIX > Chapter 306 - Watercraft Regulation and Licensing--State Water Patrol
NevadaNevada Revised Statutes > Chapter 488 - Watercraft
New HampshireNew Hampshire Revised Statutes > Chapter 270-A - Use Of Houseboats
New Hampshire Revised Statutes > Chapter 270-B - Abandoned Boats
New Hampshire Revised Statutes > Chapter 270-D - Boating And Water Safety On New Hampshire Public Waters
New Hampshire Revised Statutes > Chapter 270-E - Vessel Registration And Numbering
New MexicoNew Mexico Statutes Chapter 66 > Article 12 - Boating
New Mexico Statutes Chapter 66 > Article 13 - Boating While Intoxicated
New YorkNew York Laws - General Business > Article 38 - Vessel Dealer Agreements
New YorkNew York Laws > General Business > Article 38 - Vessel Dealer Agreements
North CarolinaNorth Carolina General Statutes Chapter 75A - Boating and Water Safety
North DakotaNorth Dakota Code > Chapter 20.1-13 - Boating Regulation
North Dakota Code > Chapter 20.1-13.1 - Intoxication Testing of Boat Operators
North Dakota Code > Chapter 20.1-17 - Aquatic Nuisance Species
OhioOhio Code > Title 15 > Chapter 1547 - Watercraft And Waterways
Ohio Code > Title 15 > Chapter 1548 - Watercraft Certificates Of Title
Ohio Code > Title 45 > Chapter 4585 - Actions Relating To Watercraft
OregonOregon Statutes > Title 61 - Small Watercraft
Rhode IslandRhode Island General Laws > Chapter 46-8. Registration of Outboard Motors
Rhode Island General Laws > Chapter 46-9. Pilots – Rhode Island Sound, Narragansett Bay, Sakonnet River, and Tributaries
Rhode Island General Laws > Chapter 46-9.1. Pilots–Block Island Sound
Rhode Island General Laws > Chapter 46-22. Regulation of Boats
Rhode Island General Laws > Chapter 46-22.1. Uniform Boat Title Act
Rhode Island General Laws > Chapter 46-22.2. Alcohol Boating Safety Act
Rhode Island General Laws > Chapter 46-27. Personal Watercraft Safety Act
South CarolinaSouth Carolina Code > Title 29 > Chapter 9 - Liens On Ships And Vessels
South Carolina Code > Title 50 > Chapter 21 - Equipment And Operation Of Watercraft
South Carolina Code > Title 50 > Chapter 23 - Watercraft And Outboard Motors
South Carolina Code > Title 50 > Chapter 25 - Boating And Surfing At Particular Localities
South DakotaSouth Dakota Laws > Title 32 > Chapter 03A - Title, Registration And Taxation Of Boats
South Dakota Laws > Title 32 > Chapter 07B - Regulation Of Boat Dealers
South Dakota Laws > Title 42 > Chapter 8 - Watercraft
TennesseeTennessee Code > Title 69 > Chapter 9 - Boating Regulation
TexasTexas Civil Statutes > Title 132 > Chapter 19 - Boat Or Motor Manufacturers, Distributors, And Dealers
UtahUtah Code > Title 73 > Chapter 18 - State Boating Act
Utah Code > Title 73 > Chapter 18 - Boating - Litter and Pollution Control
Utah Code > Title 73 > Chapter 18 - Water Safety
Utah Code > Title 73 > Chapter 18 - Financial Responsibility of Motorboat Owners and Operators Act
VermontVermont Statutes > Title 25 > Chapter 1 - Operation of Vessels
VirginiaVirginia Code Title 29.1 > Chapter 7 - Boating Laws
Virginia Code Title 29.1 > Chapter 8 - Watercraft Dealer Licensing Act
Virginia Code Title 62.1 > Chapter 18 - Protection of Aids to Navigation
WisconsinWisconsin Statutes > Chapter 30 > Subchapter V - Regulation Of Boating

Comments (0)add comment

Post a comment or question below.
smaller | bigger

busy
 
Email  Email Print  Print   Digg

monotone-frail