Ohio Code 2307.73 – Liability of manufacturer – enterprise liability rejected
(A) A manufacturer is subject to liability for compensatory damages based on a product liability claim only if the claimant establishes, by a preponderance of the evidence, all of the following:
Terms Used In Ohio Code 2307.73
- Damages: Money paid by defendants to successful plaintiffs in civil cases to compensate the plaintiffs for their injuries.
- Evidence: Information presented in testimony or in documents that is used to persuade the fact finder (judge or jury) to decide the case for one side or the other.
(1) Subject to division (B) of this section, the manufacturer’s product in question was defective in manufacture or construction as described in section 2307.74 of the Revised Code, was defective in design or formulation as described in section 2307.75 of the Revised Code, was defective due to inadequate warning or instruction as described in section 2307.76 of the Revised Code, or was defective because it did not conform to a representation made by its manufacturer as described in section 2307.77 of the Revised Code;
(2) A defective aspect of the manufacturer’s product in question as described in division (A)(1) of this section was a proximate cause of harm for which the claimant seeks to recover compensatory damages;
(3) The manufacturer designed, formulated, produced, constructed, created, assembled, or rebuilt the actual product that was the cause of harm for which the claimant seeks to recover compensatory damages.
(B) If a claimant is unable because the manufacturer’s product in question was destroyed to establish by direct evidence that the manufacturer’s product in question was defective or if a claimant otherwise is unable to establish by direct evidence that the manufacturer’s product in question was defective, then, consistent with the Rules of Evidence, it shall be sufficient for the claimant to present circumstantial or other competent evidence that establishes, by a preponderance of the evidence, that the manufacturer’s product in question was defective in any one of the four respects specified in division (A)(1) of this section.
(C) Proof that a manufacturer designed, formulated, produced, constructed, created, assembled, or rebuilt the type of product in question is not proof that the manufacturer designed, formulated, produced, constructed, created, assembled, or rebuilt the actual defective product in the product liability claim. A manufacturer may not be held liable in a product liability action based on market share, enterprise, or industrywide liability.