Certain material is incorporated by reference into this part with the approval of the Director of the Federal Register under 5 U.S.C. § 552(a) and 1 CFR part 51. To enforce any edition other than that specified in this section, the Federal Communications Commission (FCC) must publish a document in the Federal Register and the material must be available to the public. All approved incorporation by reference (IBR) material is available for inspection at the FCC and at the National Archives and Records Administration (NARA). Contact the FCC at the address indicated in 47 CFR 0.401(a), phone: (202) 418-0270. For information on the availability of this material at NARA, visit www.archives.gov/federal-register/cfr/ibr-locations.html or email fr.inspection@nara.gov. The material may be obtained from the following source(s):

(a) International Electrotechnical Commission (IEC), IEC Central Office, 3, rue de Varembe, CH-1211 Geneva 20, Switzerland; email: inmail@iec.ch; website: www.iec.ch.

(1) CISPR 16-1-4:2010-04, Specification for radio disturbance and immunity measuring apparatus and methods—Part 1-4: Radio disturbance and immunity measuring apparatus—Antennas and test sites for radiated disturbance measurements, Edition 3.0, 2010-04; IBR approved for § 2.948(d).

(2) [Reserved]

(b) Institute of Electrical and Electronic Engineers (IEEE), 3916 Ranchero Drive, Ann Arbor, MI 48108; phone: (800) 678-4333; email: stds-info@ieee.org; website: www.ieee.org/.

(1) ANSI C63.4-2014, American National Standard for Methods of Measurement of Radio-Noise Emissions from Low-Voltage Electrical and Electronic Equipment in the Range of 9 kHz to 40 GHz, ANSI-approved June 13, 2014, Sections 5.4.4 (“Radiated emission test facilities—Site validation”) through 5.5 (“Radiated emission test facilities for frequencies above 1 GHz (1 GHz to 40 GHz)”), copyright 2014; IBR approved for § 2.948(d).

(2) ANSI C63.4a-2017, American National Standard for Methods of Measurement of Radio-Noise Emissions from Low-Voltage Electrical and Electronic Equipment in the Range of 9 kHz to 40 GHz, Amendment 1: Test Site Validation, ANSI-approved September 15, 2017; IBR approved for § 2.948(d).

(3) ANSI C63.25.1-2018, American National Standard Validation Methods for Radiated Emission Test Sites, 1 GHz to 18 GHz, ANSI-approved December 17, 2018; IBR approved for § 2.948(d).

(4) ANSI C63.26-2015, American National Standard of Procedures for Compliance Testing of Transmitters Used in Licensed Radio Services, ANSI-approved December 11, 2015; IBR approved for § 2.1041(b).

(c) International Organization for Standardization (ISO), Ch. de Blandonnet 8, CP 401, CH-1214 Vernier, Geneva, Switzerland; phone: + 41 22 749 01 11; fax: + 41 22 749 09 47; email: central@iso.org; website: www.iso.org.

(1) ISO/IEC 17011:2004(E), Conformity assessment—General requirements for accreditation bodies accrediting conformity assessment bodies, First Edition, 2004-09-01; IBR approved for §§ 2.948(e); 2.949(b); 2.960(c).

(2) ISO/IEC 17025:2005(E), General requirements for the competence of testing and calibration laboratories, Second Edition, 2005-05-15; IBR approved for §§ 2.948(e); 2.949(b); 2.950(a); 2.962(c) and (d).

(3) ISO/IEC 17025:2017(E), General requirements for the competence of testing and calibration laboratories, Third Edition, November 2017; IBR approved for §§ 2.948(e); 2.949(b); 2.950(a); 2.962(c) and (d).

(4) ISO/IEC 17065:2012(E), Conformity assessment—Requirements for bodies certifying products, processes and services, First Edition, 2012-09-15; IBR approved for §§ 2.960(b); 2.962(b), (c), (d), (f), and (g).

Note 1 to § 2.910:

The standards listed in paragraphs (b) and (c) of this section are also available from the American National Standards Institute (ANSI), 25 West 43rd Street, 4th Floor, New York, NY 10036; phone (212) 642-4980; email info@ansi.org; website: https://webstore.ansi.org/.

[88 FR 67114, Sept. 29, 2023]