7 CFR 51.1438 – Size classifications for pieces
Current as of: 2024 | Check for updates
|
Other versions
The size of pecan pieces in a lot may be specified in accordance with one of the size classifications shown in Table II.
Table II
Size classification | Maximum diameter (will pass through round opening of following diameter) | Minimum diameter (will not pass through round opening of following diameter) (inch) |
---|---|---|
Mammoth pieces | No limitation | |
Extra large pieces | ||
Halves and pieces | No limitation | |
Large pieces | ||
Medium pieces | ||
Small pieces | ||
Extra small pieces | ||
Granules |
(a) In lieu of the size classifications in Table II, the size of pieces in a lot may be specified in terms of minimum diameter, or as a range described in terms of minimum and maximum diameters expressed in sixteenths or sixty-fourths of an inch.
(b) Tolerances for size of pieces: In order to allow for variations incident to proper sizing, tolerances are provided for pieces in a lot which fail to meet the requirements of any size specified. The tolerances, by weight, are shown in Table III.
Table III
[Percent]
Size classification | Total tolerance for offsize pieces | Tolerance (included in total tolerance) for pieces smaller than | |
---|---|---|---|
Mammoth pieces | 15 | 1 | |
Extra large pieces | 15 | 1 | |
Halves and pieces | 15 | 1 | |
Large pieces | 15 | 1 | |
Medium pieces | 15 | 2 | |
Small pieces | 15 | 2 | |
Extra small pieces | 15 | 2 | |
Granules | 15 | 5 | |
Other specified size | 15 | 1 |