14 CFR 25.103 – Stall speed
(a) The reference stall speed, V
is first a maximum during the maneuver prescribed in paragraph (c) of this section. In addition, when the maneuver is limited by a device that abruptly pushes the nose down at a selected angle of attack (e.g., a stick pusher), V
(b) V
(1) Engines idling, or, if that resultant thrust causes an appreciable decrease in stall speed, not more than zero thrust at the stall speed;
(2) Propeller pitch controls (if applicable) in the takeoff position;
(3) The airplane in other respects (such as flaps, landing gear, and ice accretions) in the condition existing in the test or performance standard in which V
(4) The weight used when V
(5) The center of gravity position that results in the highest value of reference stall speed; and
(6) The airplane trimmed for straight flight at a speed selected by the applicant, but not less than 1.13V
(c) Starting from the stabilized trim condition, apply the longitudinal control to decelerate the airplane so that the speed reduction does not exceed one knot per second.
(d) In addition to the requirements of paragraph (a) of this section, when a device that abruptly pushes the nose down at a selected angle of attack (e.g., a stick pusher) is installed, the reference stall speed, V